Owner`s manual

4 . 3 A u d i o C o n n e c t i o n s
4.3.1 SIGNAL CABLE
Use a good quality, 2-conductor shielded cable for all audio input and output connections.
4.3.2 INPUT CONNECTIONS
The three, female, XLR-type connectors labeled A through C are audio input connectors.
Analog Pin-Out: XLR A to XLR C
Electronically balanced, line level
Pin 1: Shield
Pin 2: + (plus or high)
Pin 3: - (minus or low)
4.3.3 OUTPUT CONNECTIONS
The six, male, XLR-type connectors labeled 1 through 6 are the audio output connectors.
Analog: XLR 1 to XLR 6
Electronically balanced, line level.
Pin 1: shield
Pin 2: + (plus or high)
Pin 3: - (minus or low)
4 . 4 N e t w o r k C o n n e c t i o n s
4.4.1 USB
The UX3600 communicates with a computer through its built-in, front panel, USB port.
4.4.8 SOFTWARE INSTALLATION -- EAWPILOT
EAWPilot requires an IBM compatible PC equipped as follows:
Operating System: Windows Vista, XP, 2000, NT, ME, or Windows 7
The latest EAWPilot can be downloaded from the EAW web site: www.eaw.com. Go to the
“Downloads” page. Once installed and with the computer connected to the UX3600, open EAWPilot by
clicking on EAWPilot in the Start/Programs/EAW/EAWPilot.
Page 6
B
A
NALOG
A
NALOG
INPUTS
P
USH
1 SIGNAL EARTH
(CABLE SHIELD)
2 SIGNAL
3 SIGNAL
2
1
C
A
ANALOG
P
USH
1 SHIELD
3-
2+
2+
3-
1 SHIELD
PUSH
6
4
35
OUTPUTS
C
lip
-
6
-
12
Sig
MUTE
A
USB