Specifications

Page 76 of 89
The user should now turn off the noise source and restore the original mixer levels.
Once “OK” is clicked, the entire Anya system will unmute and return to its state prior
to using the Find Me function.
To define an entire venue, the user may wish to repeat this process several times,
moving the microphone to a new location within the audience area and repeating
these steps. Audience areas may then be drawn connecting these virtual microphones
to form coverage areas.
If Find Me is unsuccessful, the following dialog will appear:
This could occur for several reasons, including:
 The incorrect name is entered under “Smaart Measurement Name” in the initial
Find Me dialog.
 The API is not enabled in Smaart, or the correct port number is not set.
 The signal-to-noise ratio is insufficient to capture accurate delay times, or the
measurement system is not properly configured.
 The arrays are not near their indicated positions.
To resolve these issues, the user should first ensure that they are able to obtain a valid
transfer function measurement in Smaart. Find Me works by using the API to run the
Smaart Delay Finder multiple times and capture the results. If the Smaart Delay Finder
is not able to produce accurate results, Find Me will fail.