Specifications

Page 62 of 89
Loudspeakers
 Determine if the array or loudspeaker will be ground stacked or flown.
 Select the product that will be used at the top of your array from the
dropdown menu labeled Top. Only products that have been selected in the
Inventory Manager will be visible in this dropdown menu.
 Select how many elements of that product are available to form an Array. This
is a number that the software will draw from. It is not guaranteed that the
exact number will be used but the software will not use more than what you
say is available.
 Select the EAW Greybox that you wish to use with this product. Some products
have multiple Greyboxes available while others may have only a single
selection.
 If you are building an Array with a different model loudspeaker for the lower
section, then select that model from the dropdown menu labeled Bottom. For
example, you may want to build an array with KF740s on top with KF730s on
the bottom.
 Select the EAW Greybox that you wish to use with this product. Some products
have multiple Greyboxes available while others may have only a single
selection.
Flybar
 Some EAW products have more than one flybar available. A case for this is the
KF760 which has two generations of flybars. This feature allows the user to
select the flybar that they have in inventory. This is important as each flybar
will produce a different set of mechanical data.
 EAW Flybars will also have a choice of hanging options. Some may have more
than 3 so it is important to select what method you will use to hang your flybar.
Array Location
One final step on the first page of the array assistant will allow you to place the
array within the model.
 Hang Point X - This allows you to place the loudspeaker or array along the X-
axis of the model. Normally this value would be set to zero but not always,
especially when you are building a room model that is designed in a full 360
degrees.
 Hang Point Y - This allows you to place the loudspeaker or array along the Y-
axis of the model. When left at zero, the array will present itself in the center