Specifications

Page 46 of 89
your overall design result. Left-click and hold on the Front of House position to freely
position it around the listening surface.
Editing Surfaces
 As you hover your mouse over a surface, you will notice rectangular blocks that
become visible on each side of the surface and squares that become visible on
each corner. These blocks allow you to grab and alter the dimension of the
surface. This is a coarse way of adjusting a surface but once roughed in, editing
the dimensions is easy using the Properties pane.
 Once a rectangle on a surface has been selected by left-clicking and holding on
it, you are able to pull on that surface from the rectangles location. Raising or
lowering your mouse while holding the rectangle will adjust the inclination of
the surface on that particular side.
 Left-clicking and holding a square on each corner of the surface adjusts all sides
together allowing you to increase or decrease the entire size of the surface
while also allowing transformation from square to rectangular surfaces.
Inclination changes are not available with the corner squares.
5.2 Surfaces
Beginning with a new file, Resolution 2 opens with a surface already in the Venue View
that has starting coordinates of (0, 0, 0). When you select this surface, you can see all
of its values in the Properties pane, including a default value for the length and width
of the surface.
The selected surface is highlighted in blue in the Venue View.