Specifications

Page 32 of 89
 A question mark indicates that no physical module has been associated with the
module in the model.
 A Yellow box indicates a module that has gone offline.
 A Red box indicates a module previously assigned that was not found upon
reconnecting to the Network.
 A box that occasionally flashes Green indicates the module is successfully
communicating with Resolution.
Unassigned modeled Arrays will have the list of modules or loudspeakers included in
the Array while non-arrayed loudspeakers will be shown as individual boxes with only
one device listed. Adaptive Arrays will be shown with the modules in Columns and the
meters.
A physical Adaptive Array in the Online Devices list can be assigned or associated with
a modeled Adaptive Array in the model by simply clicking on the Array in the list and
dragging it on to the appropriate modeled Array.
Note: the physical Array and modeled Array must include the same quantity and
arrangement of Anya modules).
For example, assume your model includes two Anya Arrays and you’ve named them as
“Left Array” and “Right Array”. You have assembled two, two-module arrays on-site
and physically mounted them in the corresponding positions in your model. Click on an
Array in the Online Devices list, observe which physical array has LED lights turned on
(be sure Auto Identify is enabled) and drag the Array over and on top of the
corresponding Array in the model, i.e., the left physical Array on the “Left Array” in the
model.
Proceed with assigning any remaining physical Arrays to modeled Arrays until all
Arrays have been assigned.
*Note: While we may think the LEDs are very pretty and cool, it is probably a good idea
to remember to turn Auto Identify off before the show starts!!