Specifications

EAW Smaart 6 Operation Manual
vii
List of Figures
1-1 Audio I/O tab of the Options dialog ..................................................................................14
1-2 Input levels: too low (left), correct (middle), and too high (right) ....................................15
1-3 Smaart 6 main window ......................................................................................................16
1-4 Menu bar............................................................................................................................17
1-5 Cursor readout....................................................................................................................17
1-6 Display mode (left) and Measurement mode (right) buttons.............................................18
1-7 Capture and Load buttons..................................................................................................18
1-8 Signal Generator and Delay controls.................................................................................19
1-9 Signal Generation dialog ...................................................................................................19
1-10 Signal level, SPL, and input meters...................................................................................20
2-1 Pink noise graphed on octave band (left) and narrowband logarithmic (right) scales.......27
2-2 White noise graphed on octave band (left) and narrowband logarithmic (right) scales....27
3-1 View and plot display after clicking the Spectrum button.................................................37
3-2 Impulse Response Window ...............................................................................................38
3-3 Spectrograph display..........................................................................................................40
3-4 Spectrograph dB Range .....................................................................................................41
3-5 Frequency Scale list...........................................................................................................41
3-6 Average options (left); Weight options (right) ..................................................................42
3-7 Block Diagram of a Frequency Response Measurement...................................................44
3-8 Coherence Blanking parameters in Frequency Response tab of Options dialog...............50
3-9 Block Diagram of a Delay or Impulse Response Measurement........................................52
3-10 Impulse Response window ................................................................................................53
3-11 Delay auto-locator buttons.................................................................................................56
3-12 Units/Options button at the top of the Signal Level/SPL Readout....................................57
3-13 SPL/Calibrations Options and Amplitude Calibration dialogs..........................................59
3-14 Legend dialog ....................................................................................................................61
3-15 Data Information dialog.....................................................................................................62
3-16 Delay Presets in Impulse Response window .....................................................................63
3-17 Signal Generation dialog ...................................................................................................64
4-1 RTA measurement setup....................................................................................................72