Specifications

EAW Smaart 6 Operation Manual Analysis Modes and Display Types

To operate a selected EQ device:

1. Drag the filter handles to set the filter or use the Filters controls in the dialog.

2. Set this filter or all of the device’s filters to flat by clicking the Flat or All Flat

buttons, respectively.

3. Select the Show Inverted option to invert the filter’s boost/cut display. This

overlays the inverted filter onto the Magnitude display, making it easier to create

a filter shape that precisely matches the problem being corrected.

4. Set the overall gain of this input/output from the Gain field.

5. Click the Program field’s Store and Recall buttons to store and recall filter

settings to the computer.

6. Click the Sys Control button to open the device’s System Control Options

dialog. The System control dialog’s options vary widely, depending on the

device type, but are self-explanatory to those familiar with that device.

3.10 The Locked Cursor

Smaart 6’s Locked Cursor feature creates a fixed marker at a selected point on the plot,

allowing accurate computation of the difference between that point and any other point.

When the Locked Cursor is present, three sets of cursor values are displayed above the

plot from left to right: locked cursor position, the standard mouse cursor position, and

the difference between the locked and mouse cursor positions.

In RTA and Magnitude displays, the Locked Cursor can be configured to show harmonic

and sub-harmonic frequencies for a selected (fundamental) frequency. In Impulse

mode, the Locked Cursor is set automatically to the highest point on the impulse response

plot after each measurement to highlight the propagation delay.

Create a Locked Cursor at the mouse cursor position on any Smaart 6 display except

the Spectrograph by holding down the Ctrl key while clicking the plot with the left

mouse button. This sets a locked cursor at the closest frequency data point on the top

trace or, if no traces are displayed, at the mouse cursor location. Clear the Locked cursor

by holding down the Ctrl key while clicking off the plot in the margins of the plot area

or press Ctrl + x on the keyboard.