Specifications

EAW Smaart 6 Operation Manual Getting Started
19
1.4.8 Signal Generator
Figure 1-8 Signal Generator and Delay controls
Click the button to activate the signal generator; the square indicator on the button illu-
minates green when active. To configure the signal generator:
1. Click the arrow to the right of the Signal Generator button (labeled with the
current signal generator type).
The Signal Generation dialog opens.
Figure 1-9 Signal Generation dialog
2. Select a Signal type and specify the signal level(s).
3. Specify the frequency for a sine wave (Freq1) or two frequencies (Freq1 and
Freq2) for a dual sine wave if applicable.
4. Use the spinner buttons to the right of the Level1 field (and Level2 if Dual Sine
is selected) to set the signal level, or type a value into the text field.
5. Turn on the Signal Generator by selecting the Generator ON checkbox.
6. Click OK to close the dialog.