Installation Manual

Installation Requirements
40 H-Max Series Variable Frequency Drive MN04008005E—May 2017 www.eaton.com
FS7 and FS8: Locate the EMC box under the cover. Remove
the screws of the box cover to expose the EMC-jumper.
Detach the jumper and re-fix the box cover. See figure below.
Figure 33. Removing the EMC Jumper, FS7 and FS8
FS7 only: Locate the DC grounding busbar between
connectors R- and U and detach the busbar from the frame
by undoing the M4 screw. See figure below.
Figure 34. Detaching the DC Grounding Bus Bar from
Frame, FS7