Installation Manual

Installation Requirements
H-Max Series Variable Frequency Drive MN04008005E—May 2017 www.eaton.com 39
Disconnect the RFI-filters from ground by removing the
EMC-jumpers using long-nose pliers or similar. See figure
below.
Figure 31. Removing the Jumper, FS5 as Example
Frames FS7 and FS8
Follow the procedure described below to modify the EMC
protection of the AC drive of frames FS7 and FS8 to
EMC-level C4.
Remove the main cover of the AC drive and locate the jumper.
FS8 only: Push down the grounding arm. See figure below.
Figure 32. Grounding Bar Location, FS8