Specifications
Industrial ePDUs
eaton.com/epdu 1.800.356.5794
35
Required Cable Assembly Options: CBL100: 20A with 12/5 cable 9’ long terminated with a NEMA
L21-20P for use in North America at 120/208V~
CBL102: 20A with 5x2.5mm Harmonized cable 9’ long.
A plug is not provided so that you can provide the
country specific plug for use in Europe at 230/400V~
EMI/RFI filter
• Differential mode
• Common mode
• Refer to Chart 2 on page 40
Spike/surge suppression
• Line to line
• Refer to Chart 1 on page 40
Voltage selection switch
• Select 120/208V~ or 230/400V~ input
• 120/208V~ input with 120V~ output
• 230/400V~ input with 230V~ output
Local/off/remote switching
• Local: on/off to switched outlets
• Off: When breaker is on but this switch is in the off mode, you
will have power to the unswitched outlets only
• Remote: on/off to switched outlets via a remote control device
• Latching remote, the selection switch is wired for remote/off/
remote. There is no local control on the PC302-I/LT
Remote control
• Remote on/off and EPO control, EPO overrides remote and local
control
• Sequence power up additional equipment down line
• Latching remote - (N/C) EPO, momentary start on PC302-LT only
Multiple time delay (MTD)
• Activated locally or remotely, PH-X powers up, followed four
seconds later by PH-Y, which is followed four seconds later
PH-Z, then four seconds later the sequenced remote activates
the next system in line
(6) Indicator lights
• Main power on
• Power to phase X, Y and Z
• 120/208V~ input selected
• 230/400V~ input selected
See pages 38-39 for optional control panels.
International PC302-I/MTD three-phase systems
120/208V~ or 230/400V~ Three-Phase WYE, 20A, 50/60Hz
Catalog Number
Full load
Per Phase
Main Circuit
Breaker
Receptacles
EMI/RFI Filter Per
Phase
Surge
Suppression
Input
Dimensions
(H x W x D, in)
PC302-I/MTD
1920 VA or
3680 VA
(1) 20A (14) C13 20A 270V
Terminal
Block
3.4 x 19.0 x 14.5
PC302-I/LT
1920 VA or
3680 VA
(1) 20A (14) C13 20A 270V
Terminal
Block
3.4 x 19.0 x 14.5
Front view Rear view
PC302-I/MTD