Installation Manual

Menu Information
38 9000X AF Drives MN04001004E—May 2011 www.eaton.com
System Menu Parameter Comparison Options (S5.4)
Security Menu Parameter Options (S5.5)
Note: The Security submenu is protected with a password.
Store the password in a safe place.
S5.4
Parameter
Comparison
Parameter Comparison
With the Parameter Comparison function, you can compare the actual parameter values to the values of your customized parameter sets
and those loaded to the control keypad.
The actual parameter values are first compared to those of the customized parameter Set1. If no differences are detected, a “0” is displayed
on the lowermost line of the keypad.
If any of the parameter values differ from those of the Set1 parameters, the number of the deviations is displayed together with the symbol
P (e.g. P1 ➔ P5 = five deviating values).
By pressing the right arrow button once again, you will see both the actual value and the value it was compared to. In this display, the value
on the description line (in the middle) is the default value, and the one on the value line (lowermost line) is the edited value. You can also
edit the actual value by pushing the right arrow button.
Actual values can also be compared to Set2, factory settings, and the keypad set values.
S5.5.1
Password
Range: 0–65535 Default: 0
Password
The application selection can be protected against unauthorized changes with the password function. When the password function is
enabled, the user will be prompted to enter a password before application changes, parameter value changes, or password changes.
By default, the password function is not in use. If you want to activate the password, change the value of this parameter to any number
between 1 and 65535. The password will be activated after the timeout time (Timeout Time) has expired.
To deactivate the password, reset the parameter value to 0.
P5.5.2
Parameter Lock
Range: ChangeEnable, ChangeDisabl Default: ChangeEnable
Parameter Lock
This function allows the user to prohibit changes to the parameters. If the parameter lock is activated the text *
locked
* will appear on the
display if you try to edit a parameter value.
Note: This function does not prevent unauthorized editing of parameter values.
P5.5.3
Startup Wizard
Range: Yes, No Default: No
STARTUp Wizard
The Startup Wizard facilitates commissioning the SVX9000/SPX9000. If selected active, the Startup Wizard prompts the operator for the
language and application desired and then advances through the start-up parameter list. After completion it allows the user to repeat the
Startup Wizard or return to the default page, the operate menu. The Startup Wizard is always active for the initial power up of the SVX9000/
SPX9000.
P5.5.4
Multimonitor
Items
Range: ChangeEnable, ChangeDisabl Default: ChangeEnable
Multimon.items
The keypad display can display three actual monitored values at the same time. This parameter determines if the operator is allowed to
replace the values being monitored with other values.