Firmware Manual

9000X AF Drives
6-14 For more information visit: www.eaton.com
MN04004001E
August 2010
Multi-Purpose Control Application
Output Signals
Delayed Digital Output 1 (Keypad: Menu M1 ➔ G1.3.1)
Table 6-14: Delayed Digital Output 1 Parameters — G1.3.1
Delayed Digital Output 2 (Keypad: Menu M1 ➔ G1.3.2)
Table 6-15: Delayed Digital Output 2 Parameters — G1.3.2
Code Parameter Min. Max. Unit Default Cust ID Note
P1.3.1.1

Digital output 1
signal selection
DigOUT:0.1 DigOUT:E:10 0.1 486
P1.3.1.2 Digital output 1
function
DigOUT:0.1 DigOUT:E:10 1 312 0 = Not used
1 = Ready
2 = Run
3 = Fault
4 = Fault inverted
5 = FC overheat warning
6 = Ext. fault or warning
7 = Ref. fault or warning
8 = Warning
9 = Reverse
10 = Jogging spd selected
11 = At speed
12 = Mot. regulator active
13 = Freq. limit 1 superv.
14 = Freq. limit 2 superv.
15 = Torque limit superv.
16 = Ref. limit supervision
17 = External brake control
18 = Remote control active
19 = FC temp. limit superv.
20 = Reference inverted
21 = Ext. brake control inverted
22 = Therm. fault or warn.
23 = On/Off control
24 = Fieldbus input data 1
25 = Fieldbus input data 2
26 = Fieldbus input data 3
27 = Fieldbus input data 4
28 = Fieldbus input data 5
29 = SafeDisableA
30 = CargeSW Stat
P1.3.1.3 Digital output 1
on delay
0.00 320.00 s 0.00 487 0.00 = delay not in use
P1.3.1.4 Digital output 1
off delay
0.00 320.00 s 0.00 488 0.00 = delay not in use
Code Parameter Min. Max. Unit Default Cust ID Note
P1.3.2.1

Digital output 2
signal selection
DigOUT:0.1 DigOUT:E.10 0.1 489
P1.3.2.2 Digital output 2
function
DigOUT:0.1 DigOUT:E.10 0 490 See par. 1.3.1.2
P1.3.2.3 Digital output 2 on
delay
0.00 320.00 s 0.00 491 0.00 = delay not in use
P1.3.2.4 Digital output 2 off
delay
0.00 320.00 s 0.00 492 0.00 = delay not in use