Firmware Manual

9000X AF Drives
MN04004001E
For more information visit: www.eaton.com
8-85
August 2010
Description of Parameters
1354 FB WatchdogDelay 6 (P1.7.32)
With this parameter, you activate the WatchDog timer. If bit 11 of the Main Control
Word stops cycling for this set period of time, an FB Communication Fault occurs.
1522 High Speed Mode 6 (P1.4.14)
Changes maximum fundamental output frequency from 320.0 Hz to 600.0 Hz.
1680 Safe Disable 6 (P1.3.3.29)
With this parameter, you select the digital output to show the status of the Safe
Disable. (Requires SPX drive and special card in Slot B.)
1681 ChargeSWState 6 (P1.3.3.30)
With this parameter, you select the digital output to show the status of the DC Bus
charge. Can be used to close contactor when CPX precharge is complete.
1685 LoRemButtonActive 234567
With this parameter, you can disable the local remote button on the keypad if a digital
input is used to select local and remote mode.
1686 CPX Temperature Fault 6 (P1.2.7.22)
Contact open: Fault is displayed and motor stopped.
1707 Hide Operate Menu 234567
With this parameter, you can disable the Keypad Operate Menu so the Multimonitor
Menu can be used to display three monitor values at a time. if one of the values is a
reference, the up/down arrows will adjust the reference as with the Operate Menu.