Firmware Manual

9000X AF Drives
8-50 For more information visit: www.eaton.com
MN04004001E
August 2010
Description of Parameters
Figure 8-41: An Example of Adjust Input
492 Digital output 2 off-delay 6 (P1.3.1.4)
See ID488.
493 Adjust input 6 (P1.2.1.4)
With this parameter you can select the signal, according to which the frequency
reference to the motor is fine adjusted.
0 Not used
1 Analog input 1
2 Analog input 2
3 Analog input 3
4 Analog input 4
5 Signal from fieldbus (FBProcessDataIN)
494 Adjust minimum 6 (P1.2.1.5)
495 Adjust maximum 6 (P1.2.1.6)
These parameters define the minimum and maximum of adjusted signals. See
Figure 8-41.
496

Parameter Set 1/Set 2 selection 6 (P1.2.7.21)
With this parameter you can select between Parameter Set 1 and Set 2. The input for
this function can be selected from any slot. The procedure of selecting between the
sets is explained in the 9000X AF Drives User Manual, Chapter 5.
Digital input = FALSE:
• The active set is saved to set 2
• Set 1 is loaded as the active set
Digital input = TRUE:
• The active set is saved to set 1
• Set 2 is loaded as the active set
Note: The parameter values can be changed in the active set only.
36 Hz
40 Hz
44 Hz
f/Hz
Adjusted
Adjust
Maximum
ID495 = 10%
Adjust 0%
Adjust
Minimum
ID494 = 10%
Analog Input