Firmware Manual

9000X AF Drives
MN04004001E
For more information visit: www.eaton.com
8-47
August 2010
Description of Parameters
449

Reference limit supervision 67 (P1.3.3.18, P1.3.1.18)
Active reference is beyond the set supervision low limit/high limit (see ID350 and
ID351).
450

Temperature limit supervision 67 (P1.3.3.19, P1.3.1.19)
The frequency converter heatsink temperature is beyond the set supervision limits
(see ID354 and ID355).
451

Torque limit supervision 67 (P1.3.3.20, P1.3.1.20)
The motor torque is beyond the set supervision limits (see ID348 and ID349).
452

Motor thermal protection 67 (P1.3.3.21, P1.3.1.21)
Motor thermistor initiates an overtemperature signal which can be tied to a digital
output.
Note: This parameter will not work unless you have an OPTA3 or OPTB2 (thermistor
relay board) connected.
454

Motor regulator activation 67 (P1.3.3.23, P1.3.1.23)
Overvoltage or overcurrent regulator has been activated.
455

Fieldbus input data 1
(FBFixedControlWord, bit 3)
67 (P1.3.3.24, P1.3.1.24)
456

Fieldbus input data 2
(FBFixedControlWord, bit 4)
67 (P1.3.3.25, P1.3.1.25)
457

Fieldbus input data 3
(FBFixedControlWord, bit 5)
67 (P1.3.3.26, P1.3.1.26)
The data from the fieldbus (FBFixedControlWord) can be tied to frequency converter
digital outputs.
458

Autochange 1/Auxiliary drive 1
control
7 (P1.3.1.27)
Control signal for autochange/auxiliary drive 1.
Default programming: B.1
459

Autochange 2/Auxiliary drive 2
control
7 (P1.3.1.28)
Control signal for autochange/auxiliary drive 2.
Default programming: B.2
460

Autochange 3/Auxiliary drive 3
control
7 (P1.3.1.29)
Control signal for autochange/auxiliary drive 3. If three (or more) auxiliary drives are
used, we recommend the use of a relay output to connect drive 3. Since the OPTA2
board only has two relay outputs, it is advisable to purchase an I/O expander board
with extra relay outputs (e.g. OPTB5).