Firmware Manual

9000X AF Drives
1-4 For more information visit: www.eaton.com
MN04004001E
August 2010
Basic Application
Basic Parameters (Control Keypad: M1 ➔ G1.1)
Table 1-3: Basic Parameters — G1
Code Parameter Min. Max. Unit Default Cust ID Note
P1.1 Min frequency 0.00 Par. 1.2 Hz 0.00 101
P1.2 Max frequency Par. 1.1 320.00 Hz 60.00 102 NOTE: If f
max
> than the motor
synchronous speed, check
suitability for motor and drive
system.
P1.3 Acceleration time 1 0.1 3000.0 s 3.0 103
P1.4 Deceleration time 1 0.1 3000.0 s 3.0 104
P1.5 Current limit 0.1 x I
H
2 x I
H
AI
L
107
P1.6

Nominal voltage of the
motor
180 690 V P: 230V
P: 460V
P: 575V
110 Check the rating plate of the
motor.
P1.7

Nominal frequency of
the motor
30.00 320.00 Hz 60.00 111 Check the rating plate of the
motor.
P1.8

Nominal speed of the
motor
300 20 000 rpm 1720 112 Check the rating plate of the
motor. The default applies for a
4-pole motor and a nominal size
frequency converter.
P1.9

Nominal current of the
motor
0.1 x I
H
2 x I
H
AI
H
113 Check the rating plate of the
motor.
P1.10 Preset speed 1 0.00 Par 1.1.2 Hz 10.00 105 Speeds preset by operator
P1.11 Preset speed 2 0.00 Par 1.1.2 Hz 40.00 106 Speeds preset by operator
P1.12 Input phase
supervision
0 3 730 0 = No action
1 = Working
2 = Fault
3 = Fault, coast