Product Brochure

ManualsBrandsEaton ManualsDimmers, Switches & OutletsAspire 120-Volt RF Wall Mount 5-Scene LED Keypad - Alpine White

Catalog Number

Command class to which the Basic Command Class is mapped

RF9500

Multilevel Switch Command Class

RF9501

Binary Switch Command Class

RF9505

Binary Switch Command Class

RF9505-T

Binary Switch Command Class

RF9517

Indicator Command Class

RF9518

Binary Switch Command Class

RF9534

Multilevel Switch Command Class

RF9534-N

Multilevel Switch Command Class

RF9535-N

Multilevel Switch Command Class

RF9536

Multilevel Switch Command Class

RF9536-N

Multilevel Switch Command Class

RF9537-N

Multilevel Switch Command Class

RF9542-Z

Indicator Command Class

RFAPM

Binary Switch Command Class

RFLDM

Multilevel Switch Command Class

RFTDCSG

Not Applicable – This product is a controller

RFHDCSG

Not Applicable – This product is a controller

RFUSB

Not Applicable – This product is a controller

RFUSB-PRO

Not Applicable – This product is a controller

RFWDC

Not Applicable – This product is a controller

RFMCC

Not Applicable – This product is a controller

Command Class Mapping

Z-Wave Certification requires that the Basic Command Class be

mapped to one of the supported command classes in each device.

Below is the mapping list for each Cooper AspireRF device.

Summary of content (5 pages)

PAGE 1
Command Class Mapping Z-Wave Certification requires that the Basic Command Class be mapped to one of the supported command classes in each device. Below is the mapping list for each Cooper AspireRF device.
PAGE 2
Device Configuration Parameters Cooper Z-Wave devices can be configured to operate in various ways. The configuration parameters are shown for each configurable device.
PAGE 3
RFAPM – Appliance Plug-In Module Parameter Description Value 1 Delayed Off 2 Panic On Time 3 Panic Off Time 4** Basic Set Value * 0 to 127 -128 to -1 * 0 to 127 -128 to -1 * 0 to 127 -128 to -1 * 0 to 127 -128 to -1 5 Power Up State 1=OFF 2= ON 3 = Last State 6 7 Panic Mode Enable Not Used 0=Off_1=On Not Used RFLDM - Dimmer Plug-In Module Parameter Description Value 1 Delayed Off 2 Panic On Time 3 Panic Off Time 4** Basic Set Value * 0 to 127 -128 to -1 * 0 to 127 -128 to -1 * 0
PAGE 4
Device Association Information Cooper Z-Wave devices can be associated to other Z-Wave devices for the purpose of sending commands to these other devices when a button, for example an ON/OFF button, is pressed. Cooper Z-Wave devices can hold a maximum of 5 associations to other nodes. One device can send commands to a maximum of 5 other nodes total in all association groups.
PAGE 5
Scene Transfer Protocol for the RFWDC Wall Mount Scene Controller The following protocol is used when transferring scenes from a PC based Z-Wave controller. It allows the use of devices that are scene capable as well as non-scene capable devices.