User manual

For more information visit: www.EatonElectrical.com

Commissioning

MN05013003E68

Wiring

EZ displays a small arrow in the circuit diagram for creating

the wiring.

Press ALT to activate the arrow and press the cursor buttons

ÍÚ

úí to move it.

The wiring arrow works between contacts and relays. When

you move the arrow onto a contact or relay coil, it changes

back to the cursor and can be reactivated if required.

XPress ALT to wire the cursor from

I2 through to the coil

field.

The cursor changes into a flashing wiring arrow and

automatically jumps to the next logical wiring position.

XPress the cursor button

í. Contact I2 will be connected up

to the coil field.

XPress the cursor button

í once more.

The cursor will move to the coil field.

ALT also has two other functions depending on the cursor

position:

• From the left contact field, press ALT to insert a new,

empty rung.

• The contact under the cursor can be changed between a

make and break contact by pressing the ALT button.

êê êê êêê

êê êêê

EZ automatically wires adjacent contacts in a rung up to the

coil.

I1-I2l

êê êê êê êêê

You can use the DEL button to erase a connection at the

cursor or arrow position. Where connections intersect, the

vertical connections are deleted first, then, if you press DEL

again, the horizontal connections are deleted.

EZ500_700.book Page 68 Tuesday, May 3, 2005 5:15 PM