User manual

For more information visit: www.EatonElectrical.com
Installation
MN05013003E30
For ease of wiring, leave a gap of at least 30 mm between EZ
terminals and the wall or adjacent devices.
Figure 1: Clearances to EZ
Mounting on top-hat rail
XHook EZ to the top edge of the top-hat rail and hinge into
place while pressing down slightly. Press the device lightly
downwards and against the top-hat rail until it snaps over
the lower edge of the top-hat rail.
EZ will clip into place and will be secured by the built-in spring
mechanism.
XCheck that the device is seated firmly.
EZ is mounted vertically on a top-hat rail in the same way.
30
30
30
30
1
2
EZ500_700.book Page 30 Tuesday, May 3, 2005 5:15 PM