User manual

For more information visit: www.EatonElectrical.com
Inside EZ
MN05013003E248
EZSoft EZSoft is a PC program with which you can create, store, test
(simulate) and manage EZ circuit diagrams.
Figure 91: Plug in the EZ-PC-CAB
XConnect the PC cable to the serial PC interface.
XInsert the EZ plug in the opened interface.
XActivate the Status display on the EZ
Use EZSoft to transfer circuit diagrams from your PC to EZ
and vice versa. Switch EZ to RUN mode from the PC to test
the program using the current wiring.
EZSoft provides extensive help on how to use the software.
XStart EZSoft and click on Help.
The help provides all the additional information about EZSoft
that you will need.
J
You should only transfer data between the PC and EZ using
the special PC interface cable, which is available as an
optional accessory EZ-PC-CAB.
DANGER of electric shock with EZ-AC units!
Only the EZ-PC CAB cable will guarantee reliable electrical
isolation from the interface voltage.
EZ-PC-CAB
J
EZ cannot exchange data with the PC while the circuit
diagram display is on screen.
EZ500_700.book Page 248 Tuesday, May 3, 2005 5:15 PM