User manual

Memory card
For more information visit: www.EatonElectrical.comMN05013003E 247
Loading a circuit diagram from the card
XSelect the CARD
J DEVICE menu option.
XPress OK to confirm the prompt if you want to delete the EZ
memory and replace it with the card content.
Press ESC to go back one menu.
Deleting a circuit diagram on the card
XSelect the DELETE CARD menu option.
XPress OK to confirm the prompt and to delete the card
content.
Press ESC to cancel.
DEVICE-CARD
CARD-DEVICE
DELETE CARD
Attention!
Once you have started the CARD
J DEVICE transfer, the
following operation is initiated:
• The RAM of the device is loaded from the card.
• The internal program memory is cleared.
• The data is written from the card to the internal retentive
program memory.
This is carried out in blocks. A complete program is not
transferred to the RAM for space reasons.
If an invalid program or an interruption occurs during the
read or write operation, EZ500 or EZ700 loses the program
in the internal memory.
DELETE ?
EZ500_700.book Page 247 Tuesday, May 3, 2005 5:15 PM