User manual
For more information visit: www.EatonElectrical.com
EZ Settings
MN05013003E228
Deleting retentive actual values
The retentive actual values are cleared if the following is
fulfilled (applies only in STOP mode):
• When the circuit diagram is transferred from EZSoft or the
memory card to the EZ control relay, the retentive actual
values are reset to 0. This also applies when there is no
program on the memory card. In this case the old circuit
diagram is retained in EZ.
• When the selected retentive markers, function relays or text
display are deactivated.
• When the circuit diagram is deleted via the DELETE
FUNCT menu.
The operating hours counters are always retentive. The actual
values can only be reset by means of a special reset operation
from the circuit diagram.
Transferring retentive behavior
The setting for retentive behavior is a circuit diagram setting;
in other words, the retention setting is on the memory and is
transferred with the circuit diagram when uploading or
downloading from the PC.
EZ500_700.book Page 228 Tuesday, May 3, 2005 5:15 PM