User manual

Setting date, time and daylight saving
For more information visit: www.EatonElectrical.comMN05013003E 217
XPress the OK button to access the Entry mode.
–
ÍÚ Select required value.
–
úí Move between the places.
–
ÍÚ Change the value of a parameter
– OK Save value.
– ESC Retain previous setting.
Press ESC to leave the DST setting display.
The above rule is the EU rule for the start of summer time.
J
The menu for the end of summer time has the same
structure. The values are now entered accordingly.
J
The DIFF time difference value can be modified both for the
summer time setting and the winter time setting. The value
is always the same.
Summer time means a positive value + X:XX.
Winter time means a negative value – X:XX.
J
Behavior on 29 February
If the time change is set for 29.02. at HH.MM, the switch
time for years that are not leap years will occur on 01.03 at
HH.MM.
The switch time minus the time difference should not go into
28.02. The following applies:
0:15 is put back by –30 min. New time: 28.02. 23:45
EZ500_700.book Page 217 Tuesday, May 3, 2005 5:15 PM