User manual

Password protection

For more information visit: www.EatonElectrical.comMN05013003E 201

Selecting the scope of the password

XPress the OK button.

XSelect the function or the menu to be protected.

XPress the OK button in order to protect the function or menu

(tick = protected).

• CIRCUIT DIAG: The password is effective on the program

with circuit diagram and non-enabled function relays.

• PARAMETER: The PARAMETER menu is protected.

• CLOCK: Date and time are protected with the password.

• OPRTNG MODE: The toggling of the RUN or STOP

operating mode is protected.

• INTERFACE: The interface is disabled for access with

EZSoft.

• DELETE FUNCT: The question DELETE PROG? will

appear on the device after four incorrect password entries

have been made. This prompt is not displayed if selected.

However, it is no longer possible to make changes in

protected areas if you forget the password.

CIRC.DIAG.åÆ

PARAMETER

CLOCK

OPRTNG MODEæ

INTERFACE

DELETE FUNCT

Standard protection encompasses the programs and circuit

diagram.

At least one function or menu must be protected.

EZ500_700.book Page 201 Tuesday, May 3, 2005 5:15 PM