User manual

For more information visit: www.EatonElectrical.com 199MN05013003E

5 EZ Settings

Settings can only be carried out on EZ models provided with

buttons and LCD display.

EZSoft can be used to set all models via the software.

Password protection The EZ can be protected by a password against unauthorized

access.

In this case the password consists of a value between 0001

and 9999. The number combination 0000 is used to delete a

password.

Password protection inhibits access to selected areas. The

System menu is always protected when a password is

activated.

The password can protect the following entries and areas:

• Start or modification of the program

• Transfer of a circuit diagram from and to the memory card

• Change of the RUN or STOP mode.

• Calling and modification of function block parameters

• All settings of the real-time clock.

• Modifications of all system parameters.

• Communication with the individual device.

• Switching off the password delete function.

Factory setting:

0000, no password present and none active, circuit diagram

area selected.

EZ500_700.book Page 199 Tuesday, May 3, 2005 5:15 PM