User guide

76 D OMINION PX U SER G UIDE
#8/&-$%1 D
The Device Setup Wizard is a utility program that you can use to configure an Revelation PDU
for network connectivity. In Chapter 2, you were instructed to configure the Revelation PDU by
means of a serial connection and terminal emulator such as HyperTerminal. The Device Security
Wizard is an alternative way to do this.
/-1 D
By default, the Device Setup Wizard is enabled when an Revelation PDU unit is shipped from the
factory. However, if you are concerned that the Device Setup Wizard represents a security threat,
you can disable the Wizard so that it cannot be used to configure the Revelation PDU.
To disable the wizard:
1. Access the Revelation PDU via the Web interface.
2. Select Device Settings, and then select Network. The Device Settings window appears.
3. Locate the check box labeled Disable Setup Protocol in the Miscellaneous Network
Settings panel and select it.
4. Click Apply. The Device Setup Wizard is disabled. To enable it, repeat the above three steps.
1 D
To use the Wizard to configure an Revelation PDU:
1. Launch the Device Setup Wizard. The opening Wizard window appears. This window is
primarily informational, and briefly summarizes what the Wizard can do.
Figure 76 Opening Wizard Window
2. Read the text and click Next when finished. The Device Search and Setup window appears.
This window shows the available devices, identified by MAC address. If the device you are
looking for does not immediately appear, click Refresh Devices.