User guide

50 D OMINION PX U SER G UIDE
2. Enter a time zone by selecting the appropriate Coordinated Universal Time (UTC) offset
from the drop-down list in the UTC Offset field.
3. To set the date and time manually, enter the date and time in the Date and Time fields. Use
the mm/dd/yyyy format for the date and the hh:mm:ss format for the time.
4. To let an NTP server set the date and time, click the radio button labeled Synchronize with
NTP server and enter the IP addresses of primary and secondary NTP servers in the
corresponding fields.
5. Click Apply. The date and time settings are applied.
 % '%
The Revelation PDU allows you to configure alerts to send an email message to a specific
administrator. To do this, you have to configure the Revelation PDU’s SMTP settings and enter
an IP address for your SMTP server and a sender’s email address.
Note: Refer to “Setting Up Alerts” below for instructions on configuring alerts to send emails.
1. Select Device Settings, and then select SMTP Settings. The SMTP Settings window appears.
Figure 59 SMTP Settings Window
2. Type the IP address of the mail server in the SMTP Server field.
3. Type an email address in the Sender Email Address field.
4. Click Apply. Email is configured.
'-
You can reset the Revelation PDU from the Web interface. To do this:
1. Select Maintenance, and then select Unit Reset. The Reset Operations window appears.
Figure 60 Reset Operations Window
2. Click Reset. A Reset Confirmation window appears.