User guide

48 D OMINION PX U SER G UIDE
To do all this:
1. Select Device Settings, and then select Network. The Network Settings window appears.
The Miscellaneous Network Settings panel on the top right contains the communications,
port, and bandwidth settings.
Figure 56 Miscellaneous Network Settings Panel
2. By default, CLP-Telnet is disabled and CLP-SSH is enabled. To change this, click either
check box.
3. To set an upper limit on the amount of bandwidth Telnet or SSH will be allowed to use, type
the number of kilobits per second in the Bandwidth Limit field.
4. By default, the HTTP, HTTPS, Telnet, and SSH ports are set to the standard ports for these
communications protocols. If you prefer to use different ports, you can change the port
assignments here.
5. By default the Device Setup Wizard is enabled. To disable it, click the check box labeled
Disable Setup Protocol.
Note: The Device Setup Wizard is a utility program that lets you configure an Revelation PDU
for network connectivity. If you disable it, no one will be able to use it to configure this
Revelation PDU. Refer to Appendix E for details.
6. When you are finished, click Apply. The settings are modified.
  4# $%
The LAN interface speed and duplex mode were set during the installation and configuration
process (refer to Chapter 2 for details). To modify either setting:
1. Select Device Settings, and then select Network. The Network Settings window appears.
The LAN Interface Settings panel on the bottom right shows the interface speed and duplex
mode.