User guide
C
HAPTER
4: U
SING THE
W
EB
I
NTERFACE
45
& $ '-;% '5
% '2 $
< % ' %/= $ $
/= $ $ /= $ $
/= $ $
>2 $
% '4
To configure Simple Network Management Protocol (SNMP) logging:
1. Select Device Settings, and then select Event Log. The Event Log Settings window appears.
The SNMP Logging panel controls SNMP logging.
Figure 52 SNMP Logging Panel
2. Click the check box labeled SNMP Logging Enabled.
3. Type an IP address in the Destination IP field. This is the address to which traps are sent by
the SNMP system agent.
4. Type the name of the SNMP community in the Community field. The community is the
group representing the Revelation PDU and all SNMP management stations.
5. To take a look at the Management Information Base (MIB), click the link labeled Click here
to view the <device name>) SNMP MIB. It is located under the Community field.
6. By default, when SNMP logging is enabled, seven event types appear in the Event Log
Assignments
panel to the right. All are disabled by default. To enable any of these event
types, check the appropriate check boxes.
Figure 53 Event Log Assignments Panel (List, NFS, SMTP, and SNMP Logging)
7. Click Apply. SNMP logging is configured.