User guide

% 
To avoid potentially fatal shock hazard and possible damage to Aphel equipment:
• Do not use a 2-wire power cord in any product configuration.
• Test AC outlets at your computer and monitor for proper polarity and grounding.
• Use only with grounded outlets at both the computer and monitor. When using a backup UPS,
power the computer, monitor and appliance off the supply.
• The installation socket outlet used for the power supply to this equipment must be installed
near the equipment and must be easily accessible.
•
When installing this product, it is essential that the distribution circuit supplying the product
is protected by a branch circuit protection device with a maximum rating to suit the product
maximum rating..
• SYSTEMS SHOULD ONLY BE CONFIGURED BY A COMPETENT PERSON.
• This power distribution unit is intended for power supply provision to equipment only.
Secondary (Satellite) power strips shall not be connected to the receptacles
• IT IS ESSENTIAL THAT THIS EQUIPMENT IS CONNECTED TO AN ELECTRICAL
SUPPLY THAT HAS A PROTECTIVE GROUND CONDUCTOR
• WARNING: TO ISOLATE THIS EQUIPMENT DISCONNECT POWER SUPPLY PLUG.
• ATTENTION: AFIN D'ISOLER TOTALEMENT CET APPAREIL DEBRANCHER
FICHE D'ALIMENTATION.
• CAUTION: USE ONLY IN DRY LOCATIONS.
• ATTENTION: UTILISER UNIQUEMENT DANS DES EMPLACEMENTS SECS.
• This product has been designed to conform to the latest safety requirements. In addition to
compliance with standards for general use, it has been factory configured for use in rack
mounting environments aiding the installer to provide systems compliant with relevant
standards.
$ % 
In Aphel products which require Rack Mounting, please follow these precautions:
•
Operation temperature in a closed rack environment may be greater than room temperature.
Do not exceed the rated maximum ambient temperature of the appliances (see Appendix A:
Specifications).
• Ensure sufficient airflow through the rack environment.
• Mount equipment in the rack carefully to avoid uneven mechanical loading.
• Connect equipment to the supply circuit carefully to avoid overloading circuits.
• Ground all equipment properly, especially supply connections, such as power strips (other
than direct connections), to the branch circuit.
The zero-U units are provided with high grade engineering
polycarbonate isolation hardware to allow fixing in a variety of
positions within the rack.
For panel/flush mount, pull out fixing brackets are available on
each end cap to allow mounting on suitable rails
Other options are shown below.