User guide

C HAPTER 4: U SING THE W EB I NTERFACE 35
%'-
To set the Revelation PDU thresholds:
1. Select Power Outlets, and then select Unit Setup. The Unit Setup window appears.
Figure 36 Unit Setup Window
2. Type a number in the field labeled Delay until outlets are switched on again after outlet
reset. When the outlets on the Revelation PDU are power cycled, they are turned off and then
back on. The number you enter here determines the length of time (in seconds) it takes for the
outlets to turn back on after they are shut down during the power cycle. The default is 10
seconds.
Note: The number you enter here applies to all outlets on the Revelation PDU. However, you
can override this number for specific outlets, if you wish. Refer to “Setting the Outlet
Thresholds” below. You can power cycle an outlet from the Outlet Details window. Refer to
“Power Cycling an Outlet” below for instructions.
3. Type a number of seconds in the field labeled Power on delay in ms. The default is 200
milliseconds.
4. Set the voltage, current and temperature thresholds for the unit in the Thresholds panel. For
each setting, enter critical and non-critical thresholds.
5. When you are finished, click Apply. The delays and thresholds are applied.
 .
You can give each outlet a name to help you identify the device connected to it. To do this:
1. Select Power Outlets, and then select Outlet Setup. The Outlet Setup window appears.