User guide

6 D OMINION PX U SER G UIDE
8. By default, the LAN interface duplex mode is set to Auto, which allows the system to pick
the optimum mode. Half duplex allows data to be transmitted to and from the Revelation
PDU, but not at the same time. Full duplex allows data to be transmitted in both directions at
the same time.
To keep the default, press Enter. To specify half or full duplex, type half or full and press
Enter. You are prompted to confirm the information you just entered.
Figure 8 Confirmation Prompt
9. All the configuration parameters have now been entered. All the prompts are still displayed,
so you can check the information you entered. Do one of the following:
− If the information is correct, type Y and press Enter. The system completes the
configuration and displays a message when the configuration is done.
− If one or more parameters are not correct, type N and press Enter. You are returned to
the IP configuration prompt shown in Figure 4 and given the opportunity to correct each
piece of information. When the information is correct, type
Y
and press
Enter
to
complete the configuration and return to the opening prompt shown in Figure 3.
− If you want to terminate the configuration process, type C and press Enter. The
configuration is cancelled and you are returned to the opening prompt shown in Figure 3.
10. If you entered Y to confirm the configuration, a message is displayed telling you when the
configuration is complete. You are then returned to the opening prompt shown in Figure 3.
You are now ready to begin using your Revelation PDU.
Figure 9 Configuration Complete