User guide

C HAPTER 2: I NSTALLATION AND C ONFIGURATION 5
Type your selection and press Enter. You are prompted to enable IP access control.
Figure 5 Access Control Prompt
6. By default, IP access control is NOT enabled. This disables the Revelation PDU firewall.
Leave the firewall disabled for now. Later on, you can enable the firewall from the Web
interface and create firewall rules (refer to “Configuring the Firewall” in Chapter 4 for
details).
Note: If you ever accidentally create a rule that locks you out of the Revelation PDU, you can
rerun the configuration program and reset this parameter to disabled to allow you to access the
Revelation PDU.
For now, press Enter. You are prompted to set the LAN interface speed.
Figure 6 LAN Interface Speed Prompt
7. By default, the LAN interface speed is set to Auto, which allows the system to select the
optimum speed. To keep the default, press Enter. To set the speed to 10 or 100 Mbps, type
the speed you want and press Enter. You are prompted to select the duplex mode for the
LAN interface.
Figure 7 Duplex Mode Prompt