User`s guide

UPS SETUP

Eaton 9355 Parallel UPS (10/15 kVA) User's Guide S 164201601 Rev B www.eaton.com/powerquality

2. Remove the four M4 screws securing the stabilizing bracket to the

cabinet rear panel and remove the bracket (see Figure 3). Retain the

hardware for later use.

NOTE Retain the stabilizing bracket and hardware for later re-assembly onto the cabinet.

3. Remove the front cover from the bottom cabinet to access the front

shipping bracket.

Press and release the handle latch at the bottom of the cover and

then lift the cover up and off the cabinet.

4. Remove the three M10 bolts securing the rear shipping pad to the

pallet and remove the shipping pad.