User`s guide

Getting Started
Eaton Power Xpert Gateway PXGX UPS Card User’s Guide 164202123—Rev 1 5
Connecting the Card to the Computer
To connect the card to the computer and start the configuration:
1. G o t o www.eaton.com/pxgx and download the powerxpert.inf file. Note the location of the file.
2. Plug the supplied USB cable into the Setup port on the card (see Figure 4).
Figure 4. Install the USB Cable
3. Plug the other end of the USB cable into the USB port on the computer. The Windows operating system
detects new hardware.
4. The steps for installing the USB driver software are determined by the type of operating system running
on your computer:
l
For Windows XP, go to Step 5.
l
For Windows 7, go to Step 6.
5. The Found New Hardware Wizard – Welcome window opens (see Figure 5). Continue to “Installing the
USB Driver Software (Windows XP)” on page 6.
Figure 5. Found New Hardware Wizard – Welcome Window
Power Xpert Gateway PXGX UPS
EMP Upstream Downstream
100100 Act Act Setup
Restart
Status DHCP Ident Power