User`s guide

Getting Started
Eaton Power Xpert Gateway PXGX UPS Card User’s Guide 164202123—Rev 1 19
Network Configuration
If you know the card's IP address, you can configure the network settings from the card's Web page. To
configure the network settings:
1. Open a Web browser, type the IP address of the card, and select Go.
2. Log on as administrator. The user name and default password is admin.
The PXGX UPS Card’s initial page displays (see Figure 18).
Figure 25. Initial Page – Device Overview and Summary
3. Select Network from the Configuration menu to open the Network configuration page.
4. You can enable or disable DHCP control by selecting or clearing the check box. The default is DHCP
enabled.
5. If you want the card to access other network servers (such as an SMTP server) by host name, type the
server IP address in the Name Server field. Up to three IP addresses can be entered.
6. If you will be using Simple Network Management Protocol (SNMP), identify the physical location of the
installed card in the System location field. This value also displays in the banner.
7. Enter the information to identify someone to contact with questions about this device in the System
contact field. For example, you can type a person's name, phone number, department, e-mail address, or
physical location.