System information

CA08104001E For more information visit: www.eaton.com
2.5-5
February 2009
Power Management Systems & Products
i
ii
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
Sheet 02
Power Xpert Monitoring Software
Server Core
041
Mounting Information
The most common location for the
NetLink is in a wall-mounted enclosure
near a patch panel, a network hub, or a
wall-mounted network port. Modbus
NetLinks should be mounted in close
proximity to the Modbus Master. The
distance between the Modbus Master
and the RS-232 output should not
exceed 50 feet (15 m) without the use
of external line drivers between serial
ports. The NetLink may be equipped
with up to two INCOM device network
ports. There will be an additional RJ11
jack and terminal for each INCOM
device network. Each additional port
will increase network performance in a
linear fashion. A 2-port NetLink will
deliver the same amount of data from
a fixed number of devices in half the
time of a 1-port NetLink. NetLinks will
communicate with 200 devices regard-
less of the number of ports.
Catalog Information
Table 2.5-2. Building the NetLink Catalog
Numbering System
Figure 2.5-1. Ethernet NetLink and Mounting — Dimensions in Inches (mm)
N L
Number of Ports
1 = 1 INCOM Port
Communica-
tions Network
(standard)
2 = 2 INCOM Ports
Output
E = Ethernet
Output
M = Modbus
Output
D = Dual Com-
munications
Ethernet and
Modbus
($1000 Adder)
Port Type
T = 10Base-T
Ethernet
Port/AUl
(standard)
50/60Hz 55w
NetLink
Style Number
120/230VAC 0.8A
Catalog #
MM
BEFORE REMOVING THIS COVER.
DISCONNECT POWER CORD FROM SYSTEM
HAZARDOUS VOLTAGE INSIDE.
WARNING
MODEL
Keyboard
LAN
WR/T
x
RS-232
LN
K
/Rx
Autosensing Input
50/60Hz
100-240V~1.7/0.9A
CONI-II CONI-II
RXRXTX TX
Monitor
CARRIER
Incom
CARRIER
N
1
O
R
E
T
R
E
T
1
N
O
7.78
(197.6)
4.74
(120.4)
.19
(4.8)
.18
(4.6)
9.45
(240.0)
6.93
(176.0)
6.93
(176.0)
.63 TYP
(16.0)
ø.39
ø10.0
ø.20
ø5.0
Ground
8.39
(213.1)
9.02
(229.1)
.30
(7.6)
.62
(15.7)
.20
(5.1)
.47 TYP
(12.0)
.94
(24.0)
Front View
Right Side View
Left Side View