User`s guide

OPERATION AND MAINTENANCE

Eaton ConnectUPS –MS Web/SNMP Card S 164201819 Rev 3 www.eaton.com/powerquality

Option 4: Return to Default Configuration

Select menu item 4 to restore the parameters to the factory-default configuration (see

“Card Defaults” on page 6). Wait for the confirmation message (see Figure 51).

Restart the card to save the default parameters.

Configuration has been set to default one.

You must Reset the card.

Figure 51. Default Configuration Confirmation Message

Upgrading the Card's Firmware

You can update the card’s firmware by downloading the appropriate file. During the

upgrade process, the ConnectUPS-MS Card does not monitor the UPS status.

To upgrade the firmware:

1. Download the new firmware version to your computer from the Web and note

the location.

NOTE Go to www.eaton.com/powerquality for more information on downloading firmware.

2. Click Firmware Upload from the menu bar to open the Firmware Upload page

(see Figure 52).

Figure 52. Firmware Upload Page

3. Click Browse to go to the firmware location and select the file to be loaded.

4. Click Upload.

NOTE The upload can take up to five minutes. Do not interrupt the operation before the card displays

confirmation that the firmware upload was successful (Figure 53).