User`s guide

OPERATION AND MAINTENANCE
Eaton ConnectUPS –MS Web/SNMP Card S 164201819 Rev 3 www.eaton.com/powerquality
71
t
S Modify Network settings: To modify existing network parameters (see Figure 48).
Restart the card to activate the new parameters. In DHCP mode, the card can
receive the following parameters according to the DHCP server settings:
- IP address
- Subnet mask
- Gateway address
- Primary DNS server
- Secondary DNS server
For each of the following questions, you can press <Return> to select the
value shown in braces, or you can enter a new value.
Should this target obtain IP settings from the network?[N]
Static IP address [166.99.18.129]?
Subnet Mask IP address [255.255.248.0]?
Gateway address IP address [166.99.17.1]?
Wait while your new configuration is saved ...
Reset the card to enable the new configuration.
Figure 48. Modify Network Settings
S Set Ethernet speed: To change the network speed (see Figure 49). Restart the card
to activate the new parameters.
Set the Ethernet speed : [1 : Automatic, 2 : 10 MBit]
1
New Ethernet speed : Automatic
Wait while the new setting is saved...
Reset the card to enable the new configuration.
Figure 49. Ethernet Speed Settings
Option 3: Set Login Password to Default
Select menu item 3 to return the password to the default (admin). Wait for the
confirmation message (see Figure 50). The card is now accessible using the Web
with the default password admin, but you must restart the card to save the new
password.
Login Password has successfully been set
Figure 50. Default Password Confirmation Message