User`s guide

Eaton ConnectUPS –MS Web/SNMP Card S 164201819 Rev 3 www.eaton.com/powerquality
69
t
Chapter 6 Operation and Maintenance
This chapter explains:
S Serial cable pinout
S Detailed serial configuration menus
S Firmware upgrade instructions
Serial Cable Pinout
Figure 43 shows the serial cable and pinout.
Female DB-9
Connector
Male RJ-45
Connector
Female DB-9
Connector
Male RJ-45
Connector
Frame
2
3
5
Frame
3
6
4
Shielded Cable
Figure 43. DB-9/RJ-45 Serial Cable and Pinout
Serial Configuration Menus
Use the supplied cable to connect the card to a computer.
1. Connect the card to a computer equipped with an emulator such as
HyperTerminal. Set the serial link at 9600 baud, 8 bits, no parity, 1 stop bit, and no
flow control.
2. Verify that the UPS power is on.
3. Enter the admin password (not modifiable). The ConnectUPS-MS Web/SNMP
Card main menu displays (see Figure 44).
-------------------------------------------------------------
Eaton Network Management Card
-------------------------------------------------------------
1 : Reset
2 : Network configuration
3 : Set Login Password to Default
4 : Return to Default Configuration
0 : Exit
-------------------------------------------------------------
Figure 44. ConnectUPS-MS Web/SNMP Card Main Menu