User`s guide

CONFIGURING THE CARD

Eaton ConnectUPS –MS Web/SNMP Card S 164201819 Rev 3 www.eaton.com/powerquality

S Hysteresis (temperature): Hysteresis must be set to prevent multiple notifications if

temperature fluctuates around a threshold. The default value is 2°C / -3.6°F.

The high alarm disappears when the value drops below the high threshold minus

hysteresis value.

The low alarm disappears when the value returns above the low threshold plus the

hysteresis value.

S High threshold (humidity): If the humidity exceeds the set threshold, a notification is

triggered if enabled. The default value is 90%.

S Low threshold (humidity): If the humidity falls below the set threshold, a notification

is triggered if enabled. The default value is 5%.

S Hysteresis (humidity): Hysteresis must be set to prevent multiple notifications if

humidity fluctuates around a threshold. The default value is 5%.

The high alarm disappears when the value drops below the high threshold minus

the hysteresis value.

The low alarm disappears when the value returns above the low threshold plus the

hysteresis value.

S Input #1 and Input #2: An identifier corresponding to the acquired contact (for

example: rack door, air conditioning, or generator unit). The maximum length is

28 characters.

S when closed and when open: The names associated with the two contact positions

(for example "open" and "closed" for a door, "on" and "off" for a generator).

S Notification: Notification of each status change if enabled. When the Notification

box is selected, the following functions are activated for each event selected:

- Display in the list of current alarms

- Consideration in the UPS log

- SNMP trap generation

- Notification by e-mail. The Environment Log check box must be selected on the

Email Notification page. See “E-Mail Notification“ on page 36.

NOTE See Table 9 on page 26 for a list of alarm messages.

S System Shutdown: Selection triggers a system shutdown for each selected

notification. This option is available only for parameters that have Notification

selected.

S Show advanced parameters: Selection displays the Hysteresis parameters and

system shutdown options.