User`s guide

CONFIGURING THE CARD
Eaton ConnectUPS –MS Web/SNMP Card S 164201819 Rev 3 www.eaton.com/powerquality
55
t
S Calibrate: The EMP is factory-calibrated, but you can apply an offset to adjust the
measurement.
S Input #1 and Input #2: The position of the two contacts acquired by the EMP.
The last status change of each contact is time-stamped.
The Internet browser updates this page every 10 seconds.
Environment Settings
On the Environment Settings page you can set the temperature and humidity
thresholds that trigger a notification (and a graceful shutdown of the protected
systems). See Figure 41.
NOTE If you are not already logged on, you will be prompted to enter your user name and password before
accessing this page.
The EMP measures temperature and humidity, and gives the status of the two
contacts (used for door, alarms, or generator unit).
Figure 41. Environment Settings Page (Advanced Parameters Shown)
Configurable environment settings are:
S Sensor name: The name given to the EMP. Eaton recommends using a name that
identifies the location of the EMP.
S Temperature: Choice of the temperature unit (°C or °F) from the selection box.
S High threshold (temperature): If the temperature exceeds the set threshold, a
notification is triggered if enabled. The default value is 40°C / 104°F.
S Low threshold (temperature): If the temperature falls below the set threshold, a
notification is triggered if enabled. The default value is 5°C / 41°F.