User`s guide

CONFIGURING THE CARD
Eaton ConnectUPS –MS Web/SNMP Card S 164201819 Rev 3 www.eaton.com/powerquality
41
t
S Domain Name: Indicates the domain to which the card belongs. The domain name is
the part of the fully qualified domain name that follows the host name and is used
by the DNS. The default value of the two parameters comprising the fully qualified
domain name: ups.domain.com.
S IPv6 Enabled: Authorizes (choose 'Enabled') IPv6 support.
S IPv6 Auto Config Enabled: Authorizes (choose 'Enabled') the card to obtain
configuration of IPv6 parameters from an IPv6 router. In this case, no IPv6
parameters are editable.
S IPv6 Address 1:
- If Auto Config is enabled, this field displays the first IPv6 address built from the
IPv6 router (not editable).
- If Auto Config is not enabled, this field is editable and allows users to set a
static IPv6 address.
Prefix length:
- If Auto Config is enabled, this field displays the prefix received from the router
(not editable).
- If Auto Config is not enabled, this field is editable and allows setting a prefix.
IPv6 Gateway:
- If Auto Config is enabled, this field is empty and not editable.
- If Auto Config is not enabled, this field is editable and allows users to set the
default gateway.
IPv6 Local Address: Displays the IP local address of the card, built from the MAC
address. This field is not editable. This field is always available when the IPv6 is
enabled.
IPv6 Address 2:
- If Auto Config is enabled, this field displays the second IPv6 address built from
the IPv6 router (not editable).
- If Auto Config is not enabled, this field is empty and not editable.
NOTE If the host name is not used, the IP address supplied by the DHCP server must be assigned through
Static DHCP Assignment to maintain the connection with the clients installed on the stations to be protected.
NOTE During the first connection, if the DHCP query is not successful, the ConnectUPS-MS Card starts
with the following IP configuration:
IP Address: 192.168.1.2
Subnet Mask: 255.255.255.0
Gateway Address: 0.0.0.0
S Firmware Upload: When Firmware Upload is set to Enabled, the system authorizes
remote updating of the card's embedded software. The default is Enabled.
S Primary DNS Server: Indicates the IP address of the main DNS server ensuring
conversion of the domain name to IP address.
S Secondary DNS Server: Indicates the IP address of the secondary DNS server,
ensuring conversion of the domain name to IP address if the primary DNS server is
not available.