User`s guide

CONFIGURING THE CARD

Eaton ConnectUPS –MS Web/SNMP Card S 164201819 Rev 3 www.eaton.com/powerquality

Network Settings

Select Network from the menu bar to configure the network parameters of the card

and authorize the remote upgrade of the embedded system (see Figure 31).

Figure 31. Network Settings Page

Configurable network settings are:

S IP Address: Indicates the IP address of the card (for example, 166.99.224.252).

S Subnet Mask: Indicates the mask of the subnet of your network (for example,

255.255.255.0).

S Gateway Address: Provides the IP address of the gateway to access the stations

located outside the card's subnet (for example, 166.99.17.1).

S Hostname: Indicates the card host name. The host name is the first part of the fully

qualified domain name used by the DNS.

Since the card does not support NetBIOS protocol, the host name is sent to DNS

only if the DHCP server sends the host name with the new IP address. This

mechanism is described in the update of the DNS protocol RFC 2136.