User`s guide

CONFIGURING THE CARD
Eaton ConnectUPS –MS Web/SNMP Card S 164201819 Rev 3 www.eaton.com/powerquality
37
t
Each recipient is configured with the following parameters:
S Recipient (limited to 99 characters): The e-mail address of the person or department
to receive the e-mail.
The default value is [e-mail].
Select Enabled to enable the recipient to receive e-mail messages.
Enotify: In addition to the Recipient list, you can include Eaton's eNotify Remote
Monitoring and Diagnostics Service.
S Attached files: The files selected (Measurements, Event log, System log,
Environment Log) are attached to the e-mail message. The files are sent in CSV
format.
S Periodic report: In addition to the e-mail messages sent when events occur, you can
send to the recipient at specified intervals a periodic e-mail message with the three
(optionally four) log files attached. To configure the first transmission, specify the
day, time, and frequency of the next transmission. After this date, the page shows
the date and time of the next transmission. Data is sent in CSV format.
S Email Message Settings: Access to the message configuration page.
S Network Settings: Enables you to enter the name of the SMTP server (see
“Network Settings” on page 40).
S Test: Enables you to send an e-mail message to the recipient immediately. Use this
method to check e-mail transmission—particularly to check access to the SMTP
server configured in the Network settings (see “Network Settings” on page 40). A
transmission report is added to the system log. The event label in the subject and
text of the message is replaced with a test label. If you make any modifications to
the page, you must save them before using the Test function.
S Save: Saves any modifications.
The right side of the page shows the events that can require notification. By default,
only main events, such as battery operation and a few of the UPS alarms, are
accessible. All the events display if the Show/Hide Events option is selected. By
default, only two events are selected for notification: UPS Off sequence in progress and
UPS fault. You can modify this pre-selection by clicking on other events. You can
restore the initial configuration by clicking Set Default.
For security purposes, you must click Save and enter the admin user name and
password to preserve any modifications. By default, the user name and password are
both admin.