User`s guide

CONFIGURING THE CARD

Eaton ConnectUPS –MS Web/SNMP Card S 164201819 Rev 3 www.eaton.com/powerquality

S Delayed, safe power down & reboot: This is the same switch off and then on

sequence as for the Safe power down & reboot command, but postponed by the

number of seconds programmed in the Off Delay parameter.

S Delayed On: This is the same switch on sequence as for the Immediate On

command, but postponed by the number of seconds programmed in the On Delay

parameter.

Selecting Save saves the Off Delay, Toggle Duration, and On Delay parameters on the

card.

NOTE For security purposes, the administrator must click Save and enter the admin user name and

password to save modifications or run commands. The default user name and password are both

admin.

UPS Weekly Schedule Programming

Select Weekly Schedule from the menu bar to set up the timing of specific weekly

actions (see Figure 23).

Figure 23. Weekly Schedule Page

NOTE UPS configuration can prevent the shutdown and restart commands from running properly. Refer to

the UPS user's guide for more information.

The weekly schedule enables the administrator to optimize power consumption or

program a reboot of the protected equipment at a set time.

In a shutdown sequence, the Eaton UPS Management Software connected to the

card is informed, ensuring that each machine is shut down correctly before the UPS

output is switched off. You can program up to seven UPS shutdown sequences in

one week, with a minimum shutdown delay of 30 minutes.

The On/Off sequences are valid only if the card's time has been set properly.

NOTE For security purposes, the administrator must click Save and enter the admin user name and

password to save modifications or run commands. The default user name and password are both

admin.