User`s guide

CONFIGURING THE CARD
Eaton ConnectUPS –MS Web/SNMP Card S 164201819 Rev 3 www.eaton.com/powerquality
24
t
UPS Status
The UPS Status view displays the following basic information about power and
output:
S Power source: Indicates whether power comes from the utility or from the UPS
battery.
S Output load level: Indicates the power percentage used at UPS output.
S Output: Indicates whether the individual UPS outputs are protected.
- Master (UPS): Indicates whether the UPS main output is protected.
- Group 1 and Group 2: Indicates whether the controlled load segments (if available)
are powered (see Table 7).
Table 7. UPS Output Status
Element Description
Green
Receptacle powered
Red
Receptacle not powered or not protected
S Battery load level: Remaining battery charge (in percent).
The battery load level is further described by this additional information:
- Charging: Indicates whether the utility power is present and the battery charge is
in progress.
- Discharging: Indicates whether the UPS is operating on battery.
- Fault: Indicates whether the battery is faulty.
S Remaining backup time: Estimates the battery's maximum backup time remaining
before UPS shutdown.
S Battery status: Displays result of the last automatic battery test carried out by the
UPS. Possible values are:
- OK: The test completed correctly.
- NOK: The battery needs to be checked.
- Deactivated: The automatic battery test was not validated on the UPS.