User`s guide

GETTING STARTED

Eaton ConnectUPS –MS Web/SNMP Card S 164201819 Rev 3 www.eaton.com/powerquality

Configuring the Network Without a DHCP Server

To set the network configuration manually:

1. From the main menu, type 2 and press Enter. Type 2 and press Enter again to

modify the network settings. The Network Settings menu displays (see

Figure 12).

-------------------------------------------------------------

Network settings

-------------------------------------------------------------

1 : Read Network settings

2 : Modify Network settings

3 : Set Ethernet speed

0 : Exit

-------------------------------------------------------------

For each of the following questions, you can press <Return> to select

the value shown in braces, or you can enter a new value.

Should this target obtain IP settings from the network?[N] N

Static IP address [166.99.21.94]? 166.99.21.21

Static IP address is 166.99.21.21

Subnet Mask IP address [255.255.248.0]? 255.255.255.0

Subnet Mask IP address is 255.255.255.0

Gateway address IP address [166.99.17.1]? 166.99.17.1

Gateway address IP address is 166.99.17.1

Wait while your new configuration is saved...

Reset the card to enable the new configuration.

Figure 12. Modifying the Network Settings

2. Follow the instructions and enter the static IP parameters.

Wait until Done displays, indicating that the IP parameters have been saved.

3. To exit, type 0 and press Enter.

4. Type 1 and press Enter, and then type 2 and press Enter to restart.

The card restarts with the new IP settings in approximately one minute.

NOTE The IPv6 parameters are read only through the serioal line configuration menu. If IPv6 is enabled, all

IPv6 addresses of the card can be read from the HyperTerminal

(see the previous section, “Configuring the

Network With a DHCP Server”).