User`s guide

GETTING STARTED

Eaton ConnectUPS –MS Web/SNMP Card S 164201819 Rev 3 www.eaton.com/powerquality

Connecting the Card

To connect the card to the computer and start the configuration:

1. Plug the RJ-45 end of the supplied serial cable into the Settings/Sensor port on

the card (see Figure 6).

NOTE You can set the card parameters through the Settings/Sensor port even if the network is not

connected. The Ethernet port on the card does not work for configuration.

2. Plug the other end of the serial cable into the serial COM port on the computer.

3. Connect an active Ethernet cable (not supplied) to the Ethernet port on the

ConnectUPS-MS Card (see Figure 6).

Wait approximately two minutes until the UPS Data LED flashes regularly,

indicating normal operation.

Ethernet Port

Ethernet

Settings/Sensor Port

Figure 6. Connecting the Card